Current Location: Home >> Products >> Long Ram Jack

3Ton Long Ram Jack

  • Model:T30308
  • Capacity:3 Ton

•  Double pump

•  Mounts directly onto shop cranes

•  Heat-treated chrome ram for strength and durability

•  Vertical use only

Product Information | Product Parameters | Features | Common Problems And Solutions
Product Information

This product designed for lifting. The jack can be used vertically or angled to 3 

degrees from vertical position. After lifting, loads must be immediately supported by

 appropriate means. Each model is suitable for use in lifting or positioning vehicles, 

machinery, houses and/or other building structures. This product is tested for 

reliability and safety.


Product Parameters




3 Ton

Min. Height

630 mm

Max. Height

1115 mm

N.W. / G.W.

11.4/11.7 kg

Package Size

705x280x150 mm




1680 PCS


•  Double pump

•  Mounts directly onto shop cranes

•  Heat-treated chrome ram for strength and durability

•  Vertical use only

Common Problems And Solutions

Maintain your equipment. It is recommended that the general condition of any equipment be examined before it is used. Keep your equipment in good repair by adopting a program of conscientious repair and maintenance. Have necessary repairs made by qualified service personnel.


If the moving parts of the equipment are obstructed, use cleaning solvent or another good degreaser to clean the equipment. Remove any existing rust, with a penetrating lubricant.

Do not use motor oil or grease to lubricate the equipment

Rust Prevention:

Check daily for any signs of rust or corrosion.

Without a load lift the equipment as high as it goes and look under and behind the lifting points. If signs of rust are visible clean as needed.

Storing the Equipment

1. Store in a dry location, recommended indoors.

2. Equipment should be stored in an area where they will not be subjected to damage.

3. If extreme temperatures or chemically active or abrasive environments are involved, the guidance provided in shall be followed.

4. Temperature - When equipment is used at temperatures above 140"F (60"C) or below -20"F (-29"C), the equipment manufacturer or a qualified person should be consulted.

5. Chemically Active Environments -The strength and operation of eqipment can be affected by chemically active environments such as caustic or acid substances or fumes. The equipment manufacturer or a qualified person should be consulted before equipment are used in chemically active environments.

6. Other Environments - The internal workings of equipment can be affected by high moisture, gravel or sand, silt, grit, or other dust-laden air. Equipment subject to these environments should have their inner components frequently cleaned, inspected, and lubricated.

Note: If the equipment is stored outdoors, be sure to lubricate all parts before and after use to ensure the equipment stays in good working condition.

Our Phone



Fill in your message
Tongrun WeChat


Follow The Dynamic

Company Address