Current Location: Home >> Products >> Other

Air Tire Inflating Gun

  • Model:TRG-1A
  • Capacity:

• For use with any air compressor or direct air line

• Easy to read pressure gauge from 0-12 BAR

• Give an air tight seal

• Offset dual chuck allows easy access to all valves

• Female 1/4″ NPT air inflator provides user with easy and control inflation


Product Information | Product Parameters | Features | Common Problems And Solutions
Product Information

This is Air Tire Chuck Inflator Deflator Gun with Pressure Gauge. You must use the correct type and size of tool to suit the work, keep away from children.







TRG18A 等使用图-01.jpg


Product Parameters

Model

TRG-1A


Min.Qty (Sets)

1000

Body Treatment

Power Coating


Packing

Brown Carton

Qty/CTN (PC)

40


Meas(mm)

680x380x330 mm

N.W. / G.W.

16.0/18.0 kgs


Qty/20'FT

13130 PCS


Features

• For use with any air compressor or direct air line

• Easy to read pressure gauge from 0-12 BAR

 Give an air tight seal

 Offset dual chuck allows easy access to all valves

 Female 1/4″ NPT air inflator provides user with easy and control inflation

AIR TIRE INFLATING GUN 

"Recommended working pressure:0-8bar 

WORKING PRESSURE:0-12BAR 

PRESSURE GAUGE RANGE:0-12BAR 

Length of rubber hose: 44 cm"


TRG1A-01.jpg

1517361811601239.jpg

1517361781895263.jpg


Common Problems And Solutions

Maintain your equipment. It is recommended that the general condition of any equipment be examined before it is used. Keep your equipment in good repair by adopting a program of conscientious repair and maintenance. Have necessary repairs made by qualified service personnel.

Cleaning

If the moving parts of the equipment are obstructed, use cleaning solvent or another good degreaser to clean the equipment. Remove any existing rust, with a penetrating lubricant.

Do not use motor oil or grease to lubricate the equipment

Rust Prevention:

-Check daily for any signs of rust or corrosion.

Without a load lift the equipment as high as it goes and look under and behind the lifting points. If signs of rust are visible clean as needed.

Storing the Equipment

1. Store in a dry location, recommended indoors.

2. Equipment should be stored in an area where they will not be subjected to damage.

3. If extreme temperatures or chemically active or abrasive environments are involved, the guidance provided in shall be followed.

4. Temperature - When equipment is used at temperatures above 140"F (60"C) or below -20"F (-29"C), the equipment manufacturer or a qualified person should be consulted.

5. Chemically Active Environments -The strength and operation of eqipment can be affected by chemically active environments such as caustic or acid substances or fumes. The equipment manufacturer or a qualified person should be consulted before equipment are used in chemically active environments.

6. Other Environments - The internal workings of equipment can be affected by high moisture, gravel or sand, silt, grit, or other dust-laden air. Equipment subject to these environments should have their inner components frequently cleaned, inspected, and lubricated.

Note: If the equipment is stored outdoors, be sure to lubricate all parts before and after use to ensure the equipment stays in good working condition.

Our Phone

Hotline

400-066-4786

Feedback
Contact
Telephone
Fill in your message
Tongrun WeChat

ewm2.jpg

Follow The Dynamic

Company Address

江苏省常熟市经济技术开发区

新龙腾工业园