Current Location: Home >> Products >> Air Tank

Tir Bead Blaster

  • Model:TRAD018
  • Capacity:0.6-0.8 Mpa

Portable, no need for large stationary equipment

Air inlet and exhaust port incorporate heavy-duty ball valves

• Quickly and safely seats beads on any tire

• Discharge valves allow the blast of air in one quick motion

Product Information | Product Parameters | Features | Common Problems And Solutions
Product Information

Whether you need to seat a small trailer tire or a 24.5" truck tire, this Portable Bead Seater gets you road-worthy, quicker. It operates on standard shop air and the pneumatic gauge makes it easy to check for the correct fill pressure. With its small size and ease of portability, you don't need any bulky, stationary equipment. Simply fill the 5-gallon tank using a standard air compressor and it's ready to deliver a blast of air in one quick motion. 

You can match the amount of air dispersed to the size of the tire being seated with the 1/4" air inlet shutoff valve. The lip keeps the threaded barrel at the perfect angle for air insertion during bead seating, while allowing the butterfly valve to spread the air delivering a full impact of air flow into the tire. Bead seating a tire can be a chore, Performance Tool makes it easier.


Product Parameters

Work Pressure

0.6-0.8 Mpa

Max.Work Pressure

1.0 Mpa


5 Gallon


11 kgs


12 kgs

Package Size

435x410x300 mm


450 PCS


• Portable, no need for large stationary equipment

• Air inlet and exhaust port incorporate heavy-duty ball valves

• Quickly and safely seats beads on any tire

• Discharge valves allow the blast of air in one quick motion

Common Problems And Solutions

Maintain your equipment. It is recommended that the general condition of any equipment be examined before it is used. Keep your equipment in good repair by adopting a program of conscientious repair and maintenance. Have necessary repairs made by qualified service personnel.


If the moving parts of the equipment are obstructed, use cleaning solvent or another good degreaser to clean the equipment. Remove any existing rust, with a penetrating lubricant.

Do not use motor oil or grease to lubricate the equipment

Rust Prevention:

-Check daily for any signs of rust or corrosion.

Without a load lift the equipment as high as it goes and look under and behind the lifting points. If signs of rust are visible clean as needed.

Storing the Equipment

1. Store in a dry location, recommended indoors.

2. Equipment should be stored in an area where they will not be subjected to damage.

3. If extreme temperatures or chemically active or abrasive environments are involved, the guidance provided in shall be followed.

4. Temperature - When equipment is used at temperatures above 140"F (60"C) or below -20"F (-29"C), the equipment manufacturer or a qualified person should be consulted.

5. Chemically Active Environments -The strength and operation of eqipment can be affected by chemically active environments such as caustic or acid substances or fumes. The equipment manufacturer or a qualified person should be consulted before equipment are used in chemically active environments.

6. Other Environments - The internal workings of equipment can be affected by high moisture, gravel or sand, silt, grit, or other dust-laden air. Equipment subject to these environments should have their inner components frequently cleaned, inspected, and lubricated.

Note: If the equipment is stored outdoors, be sure to lubricate all parts before and after use to ensure the equipment stays in good working condition.

Our Phone



Fill in your message
Tongrun WeChat


Follow The Dynamic

Company Address